YASH Antifog mirror

You should not cut the part of Yash anti-film which has heating elements .please select an appropriate size YASH anti-fog film;
Before the installation, ensure that it is not damaged and in working order;
The wall should be rigid and flat, avoid sharp surface as this may damage the anti-fog film;
The basic unit must do well antiseptically and deal with in case that rotten and stale damages the silver-plated floor of the mirror, that is the phenomenon to cause the mirror turning black. The board at the basic level will choose the qualified environmentally safe product too, will consider the coefficient of expansion;
You must leave some place for junction box, not less than 100*100;
While installing the anti-fog mirror, Must and conspicuous visor put into terminal box totally and in the groove of basic unit prevent cable at the intersection of fog and membrane from,The lens so as to ensure the installed mirror is in the flat state, prevent the mirror from producing and breaking because of not flattening after generating heat;
When mount the anti-fog mirror , we strongly recommend that adopt decking or ambush layout of the power cord, a single switch or light parallel with the mirror effect of sharing a switch;
The power supply cable of the anti-fog mirror should not be pulled or drawn forcefully in case of damage, redundant power supply lines can be cut when you wiring;
Because of the anti-fog mirror will trace expansion when it heating , Please allow 2mm -3mm gap between the mirror and hard substances to conveniently seal the edges by neutral silica gel;
You should check up the junction box after link up;
Use either double-sided glue or natural silica gel for installation, keep the mirror dry.